Gai-tronics 370-202, 372A Interface Amplifier Assembly for Ele Manuel d'utilisateur télécharger pdf (Page 5)

Pub. 42004-374A

Model 370-202 Interface Amplifier Assembly for Electro-Sound Page: 5 of 9

\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-374a.doc

07/05

Checkout and Adjustment

1. After the Model 370-202 is installed and connected to the power, verify that normal use of the

Page/Party

system has not been affected by the addition of the Model 370-202 Interface Amplifier

Assembly. Make sure that the GAI-Tronics sidetone level (the amount of transmitted signal from the

microphone that is heard in the receiver) is not substantially affected when the interface is connected to

the system.

If oscillation, distortion, or excessive sidetone occurs, check the Model 370-202 installation wiring and

ensure that the Model 305-001 Line Balance Assembly is properly installed and connected. See

42004-139, the GAI-Tronics 700 Series Page/Party

Systems installation manual. If normal operation

is not restored, proceed to Step 3.

2. After the Model 370-202 Interface has been installed and connected to the Electro-Sound system and

the GAI-Tronics Page/Party

system, verify that a page initiated from the Electro-Sound system can be

heard over the page speakers on the Page/Party

system.

3. After system basic operation has been verified, adjust the Model 370-202 Interface if necessary. First,

establish communications between the Electro-Sound system and the Page/Party

handset station

nearest the interface. Follow Sub-steps A through C to complete the Model 370-202 adjustment.

Adjustments are made through the plugged access holes on the front cover.

A. The Balance Control is adjusted for minimum sidetone at the GAI-Tronics station. To perform

this adjustment, blow into the microphone of the GAI-Tronics handset and adjust the balance

potentiometer on the Model 370-202 Interface to “null out” the microphone signal from the

receiver.

B. Adjust the Line to GAI-Tronics potentiometer until the volume of the voice of the caller on the

Electro-Sound system is comparable to normal voice levels on the GAI-Tronics system. (See note

below).

C. Adjust the GAI-Tronics to Line potentiometer until the volume of the signal from the GAI-Tronics

system to Electro-Sound system is comparable to normal system voice levels. (See note below).

OTE: If the LINE TO GTC and/or the GTC TO LINE controls are set too high, oscillation and

distortion may result. In this event, decrease these control settings, readjust the BALANCE

control as necessary, and reset the LINE

TO GTC and/or the GTC TO LINE controls for optimum

levels below the point at which oscillation occurs.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Gai-tronics 370-202, 372A Interface Amplifier Assembly for Ele Manuel d'utilisateur Page 5