Gai-tronics 12562-110 SMART Handset Telephone PCBA Replacement Manuel d'utilisateur télécharger pdf (Page 2)

Pub. 42003-248C

ODEL 12562-110 SMART HANDSET TELEPHONE PCBA REPLACEMENT KIT Page 2 of 10

f:\standard ioms - current release\42003 kit manuals\42003-248c.doc

02/13

Installation

Electrostatic Discharge (ESD) Protection

Your telephone may have an earth ground terminal provision. If so, ensure that it is connected to ground

in accordance with all local safety regulations and the National Electrical Code (NEC). Grounding has to

be ensured for safe and stable communications. Do not use long and coiled ground wires. Trim ground

wires to the required length. Use a star configuration whenever possible.

Models 246-003, 247-003, 256-003 & 257-003

Removing the Old PCBA

1. Use a Phillips screwdriver to remove the four front panel screws and remove the panel from the

enclosure after disconnecting the telephone line.

2. Disconnect the handset, hookswitch, push button, keypad (Models 246-003 and 256-003 only), and

ringer cable(s) from the PCBA. Record the location of each connection for later reconnection.

3. Disconnect the red and green wires from the telephone line connection on the PCBA. Save the

modular cord.

4. Depress the locking tab on each nylon standoff while lifting up on that corner of the PCBA to remove

it.

5. Clip the tie wrap securing the wires together.

Installing the New PCBA

1. Align the holes of the new PCBA with the snap-on nylon standoffs in the telephone, maintaining

proper orientation. See Figure 3 as an example.

2. Press firmly on each corner of the PCBA to lock in the standoffs.

3. Reconnect the red (ring) and green (tip) telephone wires to the PCBA.

4. Refer to Figure 1 for locations of the connectors on the new PCBA. (N

OTE: Keypad connector is

used in Models 246-003 and 256-003 only.)

5. Secure wires using tie wrap included.

6. Move jumper J12 from its current position to that shown in Figure 1.

7. Please refer to Pub. 42004-439, available at www.gai-tronics.com

, for further information regarding

board jumpers.

1 2 3 4 5 6 7 ... 10 11

Pas de commentaire

Gai-tronics 12562-110 SMART Handset Telephone PCBA Replacement Manuel d'utilisateur Page 2